SYNC is the most revolutionary and intuitive kinetic gimbal controller that allows natural and organic camera movements. It creates new possibilities for complex and impressive shots which have been impossible before with wireless operating range up to 1500m.

Available to ship: 1 working day after payment is confirmed.

SYNC Specification:

    • Transmission Distance (line sight): up to 1,500 m
    • Working Frequency: 2.4GHz
    • Output Power: Max 60mW
    • Power Supply: 16.8VDC (4S Li-ion/Li-Po Battery)
    • Working Current: Max [email protected]
    • Operating Temperature:x20\u00b0 C ~ 50\u00b0C
    • Handle Dimention (L x W x H):380mm x 38mm x 174mm
    • SYNC Controller Dimention (without antenna) (L x W x H):\n70mm x 48mm x 27mm
    • Handle Weight: 292g
    • SYNC Controller Weight: 80g

SYNC Battery Specification::

    • Battery Type: Li-ion
    • Capacity: 3400mAh
    • Voltage: 14.4V
    • Max Charge Voltage: 4.2V per cell
    • Minimum Discharge Voltage: 3.0V per cell
    • Dimensions (L x W x H): 37.5mm x 37.5mm x 69.5mm
    • Weight: 200g

Handle x1
SYNC Controller x1
SYNC Receiver x1
SYNC Battery (4S - 3400mAh)  x1
Battery Clamp x1
Carbon Tube Clamp x4
Monitor Support x2
Power Supply Cable x1
Power Distribution Cable x1
SBUS Cable x1
Micro-USB Cable x1
PPM / CANBUS Cable x1
Hexagon Screw M3 x 25 mm x4
Hexagon Screw ¼”-20 x2
2.54mm Jumper Cap x2
Allen Key M3 x1
  1. What gimbals work with SYNC?

There are 3 gimbal models which work with Canlink: H3, H7, H16.

  1. How to assemble the SYNC?

Step 1: Rotate the monitor supports 90 degrees clockwise. After that, slide them to the center position of the top handle bar

Step 2: Attach the SYNC Controller to the handle by using hexagon screws M3x35mm and battery clamp. Adjust the SYNC Controller so that it is parallel

with the side handle bar. After that, using the allen key M3 to tighten the screws.

Step 3: Attach the Li-ion Battery to the clamp

Step 4: Plug the Power Supply Cable into the Battery Output Connector. After that, plug the 4-pins connector into the Power Input Port

Step 5 (optional): Mounting the Wireless Video Link on the monitor support by using

hexagon screw ¼-20

Step 6 (optional): Mounting the Monitor on the monitor support by using hexagon

screw ¼-20

Step 7 (optional): Plug the power supply cable for Wireless Video Link and Monitor (if needed). Connecting the HDMI cable and other accessories (if needed)

*Note: For more details, please read the Quick Start Guide for SYNC - Rev 1.0

  1. How to connect the receiver to gimbal?

Step 1: Plug the SBUS cable into the SBUS Port on the SYNC Receiver

Step 2: Plug the other SBUS connector into the SBUS Port on the gimbal

*Note: For more details, please read the Quick Start Guide for SYNC - Rev 1.0

View more FAQs >
Subscribe To Our Newsletter
Subscribe for all Latest
News & Promotions!
This is a special one time offer!